Daily Archives: April 25, 2024
Front & Rear Brake Rotors + Ceramic Pads for 2019 2020 Hyundai Santa Fe
Hyundai Santa Fe 2019 2020. For your new braking system to operate at its performance capacity, it is important to’break-in’ the rotors and brake pads. This procedure is called bedding and it is encouraged you follow the steps below upon completion of the installation. Find a safe and open area where you will be able to accelerate and stop safely multiple times. Accelerate to 35mph (55km/h) and aggressively stop to 5mph (8km/h) in rapid successions without letting the brakes cool down and without stopping. Repeat this six times. Accelerate to 35mph (55km/h) and this time, moderately stop to 5mph (8km/h) in rapid successions without letting the brakes cool down and without stopping. Drive around for approximately 6-8 minutes at a moderate speed without excessively using the brakes or coming to a complete stop. For Elite XDS & Geomet OE (our coated rotors), and 3 extra minutes. Once this is complete, stop the vehicle and allow the brakes to cool down. This should take about 40 minutes or so. This concludes the bedding procedure and you can now use your brakes normally. However, certain restrictions apply. Note on UPS Extended Area Surcharge: This surcharge is levied by UPS, not Max Advanced Brakes. CT, DE, DC, IL, IN, KY, ME, MD, MA, MI, NH, NJ, NY, NC, OH, PA, RI, SC, TN, VT, VA, WV. AL, AZ, AR, CO, FL, GA, IA, KS, LA, MN, MS, MO, NE, SD, WI. CA, ID, MT, NV, NM, ND, OK, OR, TX, UT, WA, WY. Processing time is subject to change depending on holiday schedule & volume of orders.
Heavy Duty Running Boards for 05-23 Toyota Tacoma Double Cab Side Steps Nerf Bar
Heavy Duty Running Boards for 05-23 Toyota Tacoma Double Cab Side Steps Nerf Bar. 6inch side steps feature two-stair layout to provide better convenience for vehicles with lift kits and oversized wheel tires. Also allows for easier rooftop operation. Three-tube design provides more protection for the bottom and the side of the car, also preventing from getting stuck on the rocker plate or hanging obstacles. Welded brackets provide additional strength. Package contains 2 nerf bars, set of brackets & hardware; Installation can be completed within 20 minutes with no cutting or drilling. Unique powder coating offers exceptional rust and corrosion resistance so you can drive under any condition. The laser cutting step plate achieves a non-slipping step surface and reinforced grip. Proven to handle up to 550 lbs. No-hassle Service and Note. The bracket is not pre-welded on the step bars! Please confirm the cab picture in the listing before ordering. For your safety, professional installation recommended.