Tag Archives: 2010-2013
Front & Rear Drilled Slotted Rotors + Pads for 2010-2013 2014 2015 Chevy Camaro
Chevrolet Camaro 2010 2011 2012 2013 2014 2015 – 3.6 V6 Engine. 2010, 2011, 2012, 2013, 2014, 2015. 3.6 V6 Engine. For your new braking system to operate at its performance capacity, it is important to’break-in’ the rotors and brake pads. This procedure is called bedding and it is encouraged you follow the steps below upon completion of the installation. Find a safe and open area where you will be able to accelerate and stop safely multiple times. Accelerate to 35mph (55km/h) and aggressively stop to 5mph (8km/h) in rapid successions without letting the brakes cool down and without stopping. Repeat this six times. Accelerate to 35mph (55km/h) and this time, moderately stop to 5mph (8km/h) in rapid successions without letting the brakes cool down and without stopping. Drive around for approximately 6-8 minutes at a moderate speed without excessively using the brakes or coming to a complete stop. For Elite XDS & Geomet OE (our coated rotors), and 3 extra minutes. Once this is complete, stop the vehicle and allow the brakes to cool down. This should take about 40 minutes or so. This concludes the bedding procedure and you can now use your brakes normally. However, certain restrictions apply. Note on UPS Extended Area Surcharge: This surcharge is levied by UPS, not Max Advanced Brakes. CT, DE, DC, IL, IN, KY, ME, MD, MA, MI, NH, NJ, NY, NC, OH, PA, RI, SC, TN, VT, VA, WV. AL, AZ, AR, CO, FL, GA, IA, KS, LA, MN, MS, MO, NE, SD, WI. CA, ID, MT, NV, NM, ND, OK, OR, TX, UT, WA, WY. Processing time is subject to change depending on holiday schedule & volume of orders.
22Pcs Carbon Fiber Full Interior Kit Cover Trim For Infiniti G37 Sedan 2010-2013
Waterproof, high-quality, durable, high temperature resistance…. Make your car more cool. Products are made of high-quality carbon fiber material with nice textures. Products are customized according to original sizes which fit perfectly. Condition: 100% Brand New. Easy installed and No modification needed. Please clean the surface before installation. Compare the position and adjust it. Make sure the Temperture is not too low, if it is in Winter when your installation, please make the carbon fiber warm by heat gun, so it will be soft and easy to be installed. Tear off the sticker and stick it. Press it to make it stick strongly. Since there are differences between the countries and products, please measure your product’s size before place the order to avoid unnecessary in later days, thanks. Front, Left, Rear, Right. Easy Installation, Self-Adhesive, Waterproof.